Product Description
Features
- 2,000 lbs Bare Drum Hoist Capacity
- Winch housing and drum are manufactured out of marine grade aluminum for many years of salt-water service
- Support bars and fastenings manufactured in marine grade stainless steel
- White Hydraulics DR drive is used exclusively for optimum performance
- Winch main hydraulic motor drive, combined with an automatic brake, allows smooth control for raising and lowering your load
- Motor design allows winch to be used in most hydraulic systems
- Use of a case drain line is necessary for smooth brake operation.
- Assembly comes complete with aluminum winch frame and drum, and automatic-set brake arrangement
- Equipped with DR610 hydraulic motor and brake assembly for positive lifting and holding capability
- Drum measures 12” diameter flange X 10” between the flanges with 6 5/8” diameter barrel
- Weight: Approximately 145 Lbs.
- Wire Cable Storage Capacity: 250 Feet 3/8” Diameter Wire Cable, or 175 Feet of 7/16" Diameter Wire Cable, with 1” of Bare Drum Flange Still Showing Following Wire Spooling
Winch Performance
- Based upon 12 GPM @ 2000 PSI
- Bare drum Line Pull: 2,230 Lbs
- Bare drum line speed: 150 feet per Minute
- Mean drum line pull: 1,587 Lbs
- Mean drum line speed: 220 feet per Minute
- Full drum line pull: 1,230 Lbs
- Full drum line speed: 282 feet per Minute
NOTE: A simple schematic of a system utilizing a motor/brake is shown above. If you have any questions concerning the installation of the winch into your hydraulic system, please contact us and we'll be glad to assist you. Although maximum brake release pressure may be used for the brake release application, a 34 bar [500 psi] pressure reducing valve is pre-plumbed onto the winch motor to promote maximum life for the brake release piston seals. In the event of a pump or battery failure, an external pressure source may be connected to the brake release port to release the brake, allowing the winch to lower a load.
